Ferromatik Milacron JV in India still growing
Ferromatik Milacron JV in India still growing
Frohring promoted to Absolute Haitian president
Frohring promoted to Absolute Haitian president
Molding Part Design: Free Standing Boss With Four Gussets
Bosses are used in parts that will be assembled. Connect the boss to a wall or rib with a connecting rib as shown in Figure 1. If the distance of the boss from the wall makes a connecting rib impractical, design the boss with gussets as shown in Figure 2.
Hisense Group shutters Hungarian television plant
Hisense Group shutters Hungarian television plant
Injeciton Molding Guidelines: Support Ribs
Sometimes we use support ribs when design a plastic part.
Ribs should follow the proportional thickness guidelines shown below. If the rib is too thick in relation to the part wall, you may experience sinks, voids, warpage, weld lines, and longer cycle times. Position ribs in the line of flow to improve filling and prevent air entrapment.
Injection Molding Guidelines: Boss or Rib
A reinforced or protrusion on a mold part for strength or alignment during assembly or fastening.
Ribs should follow the proportional thickness guidelines shown below. If the rib is too thick in relation to the part wall, you may experience sinks, voids, warpage, weld lines, and longer cycle times. Position ribs in the line of flow to improve filling and prevent air entrapment.
Injection Molding Guidelines: Rib Details
Ribs should follow the proportional thickness guidelines shown below. If the rib is too thick in relation to the part wall, you may experience sinks, voids, warpage, weld lines, and longer cycle times. Position ribs in the line of flow to improve filling and prevent air entrapment.
Haitian ready to assemble presses in India
Haitian ready to assemble presses in India
India’s Lohia making Techne blow molding machines
India’s Lohia making Techne blow molding machines
Nissei drops out of June’s NPE show in Chicago
Nissei drops out of June’s NPE show in Chicago